Kia Picanto: Manual Transaxle System / Neutral Switch

Kia Picanto JA 2017-2021 Service & Repair Manual / Manual Transaxle System / Manual Transaxle System / Neutral Switch

Specifications

Item	Specified
Type	ON / OFF
Operating condition	Neutral gear
Operating voltage	10 V - 15 V
Operating temperature	-30°C to 100°C (-30°F to 212°F)

Components and components location

Component Location

1. Neutral switch

Description and operation

Description

•	Neutral switch signal is transmitted to ECM in neutral state.

•	The signal is blocked when gear is changed.

•	When the signal is blocked, the ECM controls the fuel injection amount mapping value for 1st gear so that vehicle can start properly.

Repair procedures

Inspection

1.	Remove the battery and battery tray. G 1.0 T-GDI KAPPA (Refer to Engine Electrical System - "Battery")

2.	Disconnect the neutral switch connector (A).

3.	Check the continuity between power terminal and signal terminal.

Removal

1.	Remove the battery and battery tray. G 1.0 T-GDI KAPPA (Refer to Engine Electrical System - "Battery")

2.	Disconnect the neutral switch connector (A).

Remove the neutral switch (A).

Tightening torque:

39.2 - 58.9 N·m (4.0 - 6.0 kgf·m, 28.9 - 43.4 lb·ft)

Installation

1.	Install in the reverse order of removal.

The neutral switch must be replaced with new one. (Do not reuse it.)

Back-up Lamp Switch

Specifications Specifications Item Specified Type ON/OFF Operating condition Reverse gear Operating voltage 10V - 15V Operating ...

Driveshaft and axle

Specifications Specification Engine T/M Joint type Max. permissible angle ...

Other information:

Kia Picanto JA 2017-2021 Owner's Manual: User Settings Mode (for type B cluster

On this mode, you can change setting of the doors, lamps, and so on. WARNING Do not adjust the User Setting while driving. You may lose your steering control and cause severe personal injury or accidents. FCW (Forward Collision Warning) (if equipped) • Autonomous Emergency Braking (i ...

Kia Picanto JA 2017-2021 Owner's Manual: Parking brake

Applying the parking brake To engage the parking brake, first apply the foot brake and then pull up the parking brake lever as far as possible. In addition it is recommended that when parking the vehicle on a incline, the shift lever should be in a low gear on manual transaxle vehicle ...