| Inspection |
| 1. | Stop the engine and then raise the vehicle using the lift. |
| 2. | Remove the oil filler plug (A).
|
| 3. | Check the condition of the oil and make sure that it is at the proper level (A).
|
| 4. | Install the oil filler plug (A).
|
| Replacement |
| 1. | Stop the engine and then raise the vehicle using the lift. |
| 2. | Remove the drain plug (A), allow the oil to drain out and then reinstall the drain plug.
|
| 3. | Remove the oil filler plug (A).
|
| 4. | Fill the manual transaxle with manual transaxle oil through the filler hole.
|
| 5. | Install the oil filler plug (A).
|
Components and components location Components 1. Control shaft complete 2. Control cable bracket 3. Transaxle support bracket 4. Roll rod bracket 5.
Components and components location Component Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the steering column shroud lower panel.
Components and components location Components Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the headlamp assembly. (Refer to Lighting System - "Headlamps") Installation 1.Install the headlamp assembly.