| Inspection |
| 1. | Stop the engine and then raise the vehicle using the lift. |
| 2. | Remove the oil filler plug (A). [Kappa 1.0 MPI / FFV, Kappa 1.2 MPI]
[Kappa 1.0 T-GDI]
|
| 3. | Check the condition of the oil and make sure that it is at the proper level (A).
|
| 4. | Install the oil filler plug (A) with a new gasket.
[Kappa 1.0 MPI / FFV, Kappa 1.2 MPI]
[Kappa 1.0 T-GDI]
|
Repair procedures Inspection Visually check the fuel lines for cracks, leakage, loose connections, deformation or tank band looseness.
Repair procedures Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm 3 times or more. 2. Remove the spark plug.
Components and components location Components 1. Door lock/unlock knob cable 2. Door inside handle cable 3. Door latch assembly Repair procedures Inspection • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to
Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).