Kia Picanto (JA): Scheduled maintenance service / Maintenance Under Severe Usage Conditions - For Gasoline Engine [Except Europe (Including Russia)]

Kia Picanto (JA) 2017-2025 Owner's Manual / Maintenance / Scheduled maintenance service / Maintenance Under Severe Usage Conditions - For Gasoline Engine [Except Europe (Including Russia)]

Maintenance operation

I : Inspect and if necessary, adjust, correct, clean or replace.

R : Replace or change.

SEVERE DRIVING CONDITIONS

A: Repeatedly driving short distance of less than 8 km (5 miles) in normal temperature or less than 16 km (10 miles) in freezing temperature.
B: Extensive engine idling or low speed driving for long distances.
C: Driving on rough, dusty, muddy, unpaved, graveled or salt-spread roads.
D: Driving in areas using salt or other corrosive materials or in very cold weather
E: Driving in heavy dust condition.
F: Driving in heavy traffic area.
G: Driving on uphill, downhill, or mountain roads repeatedly.
H: Towing a trailer or using a camper on roof rack.
I: Driving for patrol car, taxi, commercial use of vehicle towing.
J: Driving over 170 km/h (106 mph)
K: Frequently driving in stop-and-go conditions.

    The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty.

    Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil and filter changes are required.

    Other information:

    Kia Picanto (JA) 2017-2025 Service & Repair Manual: Multifunction Switch

    Specifications Specifications Items Specifications Rated voltage DC 12 V Operating temperature range -22 - 176°F (-30 - 80°C) Rated load Washer Washer : 6A (Motor load) Components and components location Component 1 .

    Kia Picanto (JA) 2017-2025 Service & Repair Manual: Sunroof Switch

    Components and components location Components Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the map lamp lens (A). 3. Remove the map lamp (B) after loosening the mounting screws. 4.

    Categories

     
    Copyright © 2025 www.kpicanto.com - 0.0269