| Components |
| [NON ISG] |

|
No.
|
Connector A
|
Connector B
|
| 1 | Low | Battery |
| 2 | Common | Illumination (+) |
| 3 | Ground | HTD |
| 4 | Middle (Low) | ISG Battery |
| 5 | Middle (High) | - |
| 6 | High | Detent out (-) |
| 7 | - | |
| 8 | Sensor REF (+5V) | |
| 9 | Intake actuator (FRE) | |
| 10 | Intake actuator (REC) | |
| 11 | Intake actuator Feedback | |
| 12 | PAB On signal | |
| 13 | PAB Off signal | |
| 14 | Ground | |
| 15 | Sensor ground | |
| 16 | Illumination (-) | |
| 17 | IGN2 | |
| 18 | IGN1 | |
| 19 | PAB IGN1 | |
| 20 | Ambient sensor (+) | |
| 21 | Evaporator sensor (+) | |
| 22 | MAX Blower on signal | |
| 23 | Seat belt reminder | |
| 24 | Rear left seat belt reminder | |
| 25 | Rear center seat belt reminder | |
| 26 | Rear right seat belt reminder | |
| 27 | - | |
| 28 | C_CAN (High) | |
| 29 | C_CAN (Low) | |
| 30 | Rear deffog switch | |
| 31 | Blower on signal to Common | |
| 32 | Ground |
| Replacement |
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
|
| 3. | Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
| 4. | Remove the driver's side shower duct (A) after loosening the screw.
|
| 5. | Disconnect the mode control cable (A).
|
| 6. | Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
|
| 7. | Remove the passenger's side shower duct (A) after loosening the screw.
|
| 8. | Disconnect the temperature control cable (A).
|
| 9. | After loosening the mounting screws, remove the A/C & heater controller unit (A).
|
| 10. | Disconnect the A/C & heater controller connectors (A).
|
| 11. | Install in the reverse order of removal. |
Controller
Heater & A/C Control Unit(Full Automatic)