| Removal |
| 1. | Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
|
| 2. | Disconnect the fuel pump motor connector (A) and fuel sender connector (B).
|
| 3. | Disconnect the fuel feed tube quick-connector (A) after removing the fixing clip (B).
|
| 4. | Remove the cushion pipe fixing clip (A), and then separate the head assembly (B) from reservoir cup.
|
| 5. | Press the fixing hook (A) with a driver and then remove fuel sender in the arrow direction.
|
| 6. | Remove the reservoir-cup (B) after releasing the fixing hooks (A).
|
| 7. | Disconnect the ground pin (A).
|
| 8. | Remove the fixing clip (A), and then assist pump assembly (B).
|
| 9. | Remove the free-filter (A) after releasing the fixing hooks.
|
| 10. | Separate the electric pump motor (A).
|
| 11. | Replace new fuel filter.
|
| Installation |
| 1. | Install in the reverse order of removal. |
Repair procedures Inspection [Fuel pump] 1.Turn ignition switch OFF and disconnect the negative (-)battery cable. 2.Remove the fuel pump assembly.
Repair procedures Removal 1.Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2.Disconnect the fuel sender connector (A).
Repair procedures Inspection Rear Wiper Motor 1.Remove the connector from the rear wiper motor. 2.Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively. 3.Check that the motor operates normally.
Components and components location Components Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the map lamp lens (A). 3. Remove the map lamp (B) after loosening the mounting screws. 4.