Kia Picanto: Front Seat / Front Seat Shield Outer Cover

Kia Picanto JA 2017-2025 Service & Repair Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Outer Cover

Components and components location
Component Location

1. Front seat shield outer cover


Repair procedures
Replacement
   
Put on gloves to protect your hands.
   
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Be careful not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the recliner handle (A) after loosening the screw.

3.
Remove the pumping lever cap (A).

4.
Remove the pumping lever (A) after loosening the mounting screws.

5.
Remove the front seat shield outer cover (A) after loosening the mounting screws.

   
Correctly remove the front seat shield outer cover to the removal procedure and direction.
Be careful not to damage the mounting bracket and hook when removing the cover.
6.
Install in the reverse order of removal.
   
Make sure the fuel filler door locks/unlocks and opens/closes properly.
Replace any damaged clips.
Front Seat Assembly
Components and components location Component Location 1. Front seat assembly Repair procedures Replacement 1. Loosen the front seat mounting bolts (A). Tighteni ...

Front Seat Shield Inner Cover
Components and components location Component Location 1. Front seat shield inner cover Repair procedures Replacement    Put on gloves to protect your han ...

Other information:

Kia Picanto JA 2017-2025 Service & Repair Manual: Drive Belt


Repair procedures Removal and Installation 1.Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2.Using the wrench, turning the auto tensioner pulley (A) counterclockwise and then insert a stopper pin (B) into the hole. ...

Kia Picanto JA 2017-2025 Service & Repair Manual: Timing Chain


Repair procedures Removal 1.Turn the crankshaft pulley and align its groove with the timing mark of the chain cover & oil pump assembly to set the piston of No.1 cylinder to the top dead center on compression stroke. 2.Remove the timing chain cover & oil pump assembly. ...

Copyright © www.kpicanto.com 2017-2025