Kia Picanto (JA): Timing System / Front Oil Seal
Repair procedures
| Replacement |
| 1. | Remove the crankshaft damper pulley.
(Refer to Drive Belt System - "Crankshaft Damper Pulley")
|
| 2. | Remove the crankshaft front oil seal (A).
|
| 3. | Using the SST (09214-1R100, 09231-H1100), install a new front oil seal, apply engine oil on the edge of new oil seal.
|
| 4. | Install the crankshaft damper pulley.
(Refer to Drive Belt System - "Crankshaft Damper Pulley")
|
Components and components location Components 1. Front oil seal 2. Timing chain cover & oil pump assembly 3. Timing chain tensioner 4. Timing chain tensioner arm 5.
Repair procedures Removal Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted surfaces.
Other information:
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Ignition Switch Assembly
Repair procedures Inspection 1.Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column. 2.Check for continuity between the terminals. 3.If continuity is not specified, replace the switch.
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Motor
Repair procedures Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.
Categories
- Manuals Home
- Kia Picanto Owners Manual
- Kia Picanto Service Manual
- Clutch Cable
- Normal Condition
- Engine Electrical System
- New on site
- Most important about car
