Kia Picanto (JA): Manual Transaxle Control System / Control Shaft Complete

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete

Components and components location

Components Location

1. Control shaft complete

Repair procedures

Removal

1.	Shift the gear to "neutral".

2.	Remove the battery and battery tray. G 1.0 T-GDI KAPPA (Refer to Engine Electrical System - "Battery")

3.	Remove the control cable from the control shaft after remove the pins (A).

Remove the control shaft complete (A).

Tightening torque :

19.6 - 26.5 N.m (2.0 - 2.7 kgf.m,14.5 - 19.5 lb-ft)

Installation

1.	Install in the reverse order of removal.

•	Install the control shaft complete after setting the neutral state.

•

Apply the sealant to the contact surface of transaxle and control shaft.

Specified sealant : Anaerobic adhesive for flange

❮Manual Transaxle Control System

Shift Lever❯

Components and components location Components 1. Knob 2. Boots 3. Shift lever assembly 4. Shift cable 5. Select cable Repair procedures Inspection 1.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Glass Defogger Switch

Repair procedures Inspection 1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).The diagnostic system (KDS/GDS) provides the following information.(1)Self diagnosis : Checking failure and code number (DTC)(2) Current data : Checking the system input/output data state (3)Actuation

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Unit