To defog inside windshield

1. Set the fan speed to the desired position.
2. Select desired temperature.
3. Press the defrost button (
).
4. The air conditioning will be turned on according to the detected ambient temperature and outside (fresh) air position will be selected automatically.
If the air conditioning and outside
(fresh) air position are not selected automatically,
adjust the corresponding
button manually. If the
position is
selected, lower fan speed is adjusted to
a higher fan speed.
To defrost outside windshield

1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot (HI) position.
3. Press the defrost button (
).
4. The air conditioning will be turned on according to the detected ambient temperature and outside (fresh) air position will be selected automatically.
If the
position is selected,
lower fan
speed is adjusted to a higher fan speed.
To defog inside windshield 1. Select any fan speed except “0” position. 2. Select desired temperature. 3. Select the or position. 4. The outside (fresh) air and air conditioning will be selected automatically.
To reduce the possibility of fogging up the inside of the windshield, the air intake or air conditioning are controlled automatically according to certain conditions such as or position.
Repair procedures Inspection 1.Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column. 2.Check for continuity between the terminals. 3.If continuity is not specified, replace the switch.
Repair procedures Inspection 1.Check for continuity between the terminals. If there is an abnormality, replace the switch. Removal • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.