| Components |
| [Roof Antenna (Radio)] |

| [Roof Antenna (Radio+GPS/GNSS+DAB+GSM)] |


| Removal |
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
|
| 3. | Disconnect the radio antenna and power connector (A).
|
| 4. | Remove the roof antenna (B) after loosening a nut (A).
|
| Installation |
| 1. | Install the roof antenna. |
| 2. | Connect the radio antenna and roof antenna power connector. |
| 3. | Install the roof trim assembly. |
| 4. | Connect the negative (-) battery terminal.
|
| Inspection |
| 1. | Check for continuity between the center poles of antenna cable.
|
| 2. | Check for continuity between the outer poles of antenna cable. There should be continuity.
|
| 3. | If there is no continuity, replace the antenna cable. |
| 4. | Check for continuity between the center pole (A) and outer pole (B) of antenna cable. There should be no continuity.
|
| 5. | If there is continuity, replace the antenna cable. |
Repair procedures Inspection Troubleshooting of the speakers When handling the speakers :• Do not cause shock to the speakers by dropping or throwing them.
Components and components location Components 1. Left Remote Control Switch (Audio + Hands free + Voice) 2. Right Remote Control Switch (Cruise+Trip Computer) Schematic diagrams Circuit Diagram [Audio] [Audio + Bluetooth] [Audio + Bluetooth + Voice] [Trip (2 Button) + SEG LCD Cluster] [Trip (2 Button) + ACC + Cruise] [Trip (2 Button) + ACC + Cruise + SLD] [Trip (4 Button) + DOT&TFT LCD Cluster] [Trip (4 Button) + ACC + Cruise] [Trip (4 Button) + ACC + Cruise + SLD] Repair procedures Removal 1.
Components and components location Component Location 1. Mode Control Actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit.
Repair procedures Replacement 1.Disconnect the negative (-) battery terminal. 2.Remove the heater unit. (Refer to Heater - "Heater Unit") 3.Remove the Evaporator temperature sensor. (Refer to Air Conditioning System - "Evaporator Temperature Sensor") 4.