Kia Picanto (JA): Safety features of your vehicle / Air bag - supplemental restraint system

Kia Picanto (JA) 2017-2026 Owner's Manual / Safety features of your vehicle / Air bag - supplemental restraint system

1. Driver’s front air bag*
2. Passenger’s front air bag*
3. Side air bag*
4. Curtain air bag*
5. Driver’s knee air bag*
6. Front passenger’s air bag ON/OFF switch*

WARNING

  • Even in vehicles with air bags, you and your passengers must always wear the safety belts provided in order to minimize the risk and severity of injury in the event of a collision or rollover.
  • SRS and pretensioners contain explosive chemicals. If scraping a vehicle without removing SRS and pretensioners from a vehicle, it may cause fire. Before scraping a vehicle, contact a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.
  • Keep the SRS parts and wirings away from water or any liquid. If the SRS components are inoperative due to exposure to water or liquids, it may cause fire or severe injury.

The ISOFIX system holds a Child Restraint System during driving and in an accident. This system is designed to make installation of the Child Restraint System easier and reduce the possibility of improperly installing your Child Restraint System.

Air bags are activated (able to inflate if necessary) only when the ignition switch is turned to the ON or START position. Air bags inflate instantly in the event of a serious frontal collision or side collision (if equipped with a side air bag or curtain air bag) in order to help protect the occupants from serious physical injury.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Antenna Coil

Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the steering column upper and lower shroud panel. (Refer to Body - "Steering Column Shroud Panel") 4.

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

Categories

 
Copyright © 2026 www.kpicanto.com - 0.0204